Trane Z Wave TZEMT400AB32MAA Thermostat Troubleshooting Heating or Cooling is being displayed, but no air coming from registers/ ventsġ) Wait one minute for blower delay to end, then recheck register/grillsġ) Intended operation if objectionable, change fan mode to "Auto"ġ) Smart continuous fan is enabled and the indoor humidity is higher than the cooling target RH (SCF will be displayed on fan mode button)ġ) Intended operation if objectionable, disable SCF or raise cooling target humidity
Room temperature overshoots the desired setpoint in heating modeġ) The delta ‘Off in heating mode is set to a positive numberġ) Intended operation if objectionable, change the delta “OfT' to 0 degreesĢ) Minimum compressor/indoor heat on time has not been metĢ) Intended operation if objectionable, lower the minimum on time (lowest setting available is 3 minutes)ġ) System mode is not set to Cool/Auto or setpoint is set too highġ) Select the correct system mode and/or lower the setpointĢ) Delta “On" for cooling is set too highĢ) Change the delta “On" setting for cooling modeģ) Minimum off time delay is being enforcedģ) Intended operation if objectionable, lower the minimum off time delay (lowest setting is 5 minutes)ġ) System mode is not set to Heat/Auto or setpoint is set too lowġ) Select the correct system mode and/or raise the setpointĢ) Delta “On" for heating is set too highĢ) Change the delta “On" setting for heating mode Room temperature overshoots the desired setpoint in cooling modeġ) The delta ‘Off in cooling mode is set to a negative numberġ) Intended operation if objectionable, change the delta “Off” to 0 degreesĢ) Cooling overshoot is enabled and the indoor RH is higher than the target cooling RHĢ) Intended operation: if objectionable, disable cooling over- shoot or raise cooling target RHģ) Minimum compressor on time has not been metģ) Intended operation if objectionable, lower minimum on time (lowest setting available is 3 minutes) Loss of 24VAC between R & C at the Controlģ) Check for broken or shorted thermostat wireġ) Indoor temperature display needs calibrating (always allow 1 hour before calibrating after any power cycle)Ģ) Heat from the touchscreen is being trapped within the body of the controlĢ) Relocate the control away from any competing air sources or redirect the air sources away from the control Trane 7CONT624AS42DA Thermostat Troubleshooting Wa_cq_url: "/content/Each manual enlists the most widespread technical failures, suggests possible causes and instructs on how to solve the problem. Wa_english_title: "Intel | Data Center Solutions, IoT, and PC Innovation",
0 kommentar(er)
